Computer Networks

21. Write short notes on VRC.        

The most common and least expensive mechanism for error detection is the vertical redundancy check (VRC) often called a parity check. In this technique a redundant bit called a parity bit, is appended to every data unit so, that the total number of 0’s in the unit (including the parity bit) becomes even.

22. Write short notes on LRC.

In longitudinal redundancy check (LRC), a block of bits is divided into rows and a redundant row of bits is added to the whole block.

23. Write short notes on CRC.

The third and most powerful of the redundancy checking techniques is the cyclic redundancy checks (CRC) CRC is based on binary division. Here a sequence of redundant bits, called the CRC remainder is appended to the end of data unit.

24. Write short notes on CRC checker.

A CRC checker functions exactly like a generator. After receiving the data appended with the CRC it does the same modulo-2 division. If the remainder is all 0’s the CRC is dropped and the data accepted. Otherwise, the received stream of bits is discarded and the dates are resent.

25. Define checksum.

The error detection method used by the higher layer protocol is called checksum. Checksum is based on the concept of redundancy.

 26. What are the steps followed in checksum generator?

The sender follows these steps a) the units are divided into k sections each of n bits. b) All sections are added together using 2’s complement to get the sum. c) The sum is complemented and become the checksum. d) The checksum is sent with the data.

27. Mention the types of error correcting methods.

There are 2 error-correcting methods.

·         Single bit error correction

·         Burst error correction.

28. Write short notes on error correction?

            It is the mechanism to correct the errors and it can be handled in 2 ways.

·         When an error is discovered, the receiver can have the sender retransmit the entire data unit.

·         A receiver can use an error correcting coder, which automatically corrects certain errors.

29. What is the purpose of hamming code?

A hamming code can be designed to correct burst errors of certain lengths. So the simple strategy used by the hamming code to correct single bit errors must be redesigned to be applicable for multiple bit correction.

30. What is redundancy?

It is the error detecting mechanism, which means a shorter group of bits or extra bits may be appended at the destination of each unit. 

31. Define flow control?

Flow control refers to a set of procedures used to restrict the amount of data. The sender can send before waiting for acknowledgment.

  

32. Mention the categories of flow control?

There are 2 methods have been developed to control flow of data across communication links. a) Stop and wait- send one from at a time. b) Sliding window- send several frames at a time.

33. What is a buffer?

Each receiving device has a block of memory called a buffer, reserved for storing incoming data until they are processed.